Mitsubishi Electric Lancer Evolution-VII Workshop Manual page 835

27B-18
Gear oil
Filler plug
Gear oil
6 mm
Upper limit
Lower limit
Filler plug
Oil suction gun
(general service tool)
REAR AXLE - REAR AXLE -
4. Fit the filler plug and tighten it to the specified torque.
<Vehicles with AYC>
Differential part
1. Remove the drain plug to discharge the gear oil.
2. Fit the drain plug and tighten it to the specified torque.
3. Remove the filler plug and add the specified gear oil
Drain plug
4. Fit the filler plug and tighten it to the specified torque.
Torque transfer mechanism part
1. Remove the drain plug to discharge the gear oil.
2. Fit the drain plug and tighten it to the specified torque.
3. Remove the filler plug.
4. Using the oil suction gun (general service tool), between
Drain plug
5. Fit the filler plug and tighten it to the specified torque.
On-vehicle Service On-vehicle Service
Specified gear oil:
Hypoid gear oil
MITSUBISHI Genuine Gear Oil Part No. 8149630
EX, CASTROL HYPOY LS (GL-5, SAE 90),
SHELL-LSD (GL-5, SAE 80W - 90) or equivalent
Quantity: 0.55 L
Tightening torque: 49 ± 9 N·m
Tightening torque: 49 ± 9 N·m
up to the bottom end of the filler plug hole.
Specified gear oil:
Hypoid gear oil API classification GL-5 or higher
SAE viscosity Number 90, 80W
Quantity: 0.55 ± 0.02 L
NOTE
10_C or more: SAE90, less than 10_C: SAE80W
Tightening torque: 49 ± 9 N·m
Tightening torque: 49 ± 9 N·m
the body and differential support arm, apply the specified
gear oil up to the under of the filler plug hall.
Specified gear oil: ATF-SP III
Quantity: 0.65 - 0.7 L
Tightening torque: 49 ± 9 N·m