Mitsubishi Electric Lancer Evolution-VII Workshop Manual page 701

37A-24
STEERING - Power Steering Gear Box and Linkage
MB991199
Gear housing
Oil seal
Needle
MB990925
bearing
(MB990938)
MB991202
Vent hole
Seal ring, O-ring
Oil seal
MB991214
REASSEMBLY SERVICE POINTS
"AA OIL SEAL INSTALLATION
MB991197
"BA NEEDLE BEARING/LOWER BEARING
MB990925
(MB990938)
MB991202
Lower
bearing
"CA RACK ASSEMBLY INSTALLATION
1. Apply repair kit grease to the teeth of the rack assembly.
Caution
Use care not to close the vent hole in the rack with
grease.
2. Cover the serrations of the rack assembly with the special
tool.
3. Apply specified fluid to the outer surfaces of the special
tool, seal ring and O-ring.
Specified fluid:
Caution
Do not use ATF-SP II M and ATF-SP III.
4. Slowly insert the rack covered with the special tool from
the power cylinder side of the gear housing.
Caution
Carefully push in the rack with the oil seal centre
and the special tool end matched. This is to avoid
the retainer spring coming off.
INSTALLATION
Automatic transmission fluid DEXRON II