Mitsubishi Electric Lancer Evolution-VII Workshop Manual page 650

MB990784
BODY -
Window Glass
REMOVAL SERVICE POINTS
AA" REAR WINDOW LOWER MOLDING REMOVAL
Pry the rear window lower molding off with the special tool.
Caution
Do not use a deformed molding.
AB" REAR WINDOW GLASS REMOVAL
Remove the rear window glass in the same manner as for
the windshield. (Refer to P42-12.)
INSTALLATION SERVICE POINTS
"AAGLASS STOPPER/WINDOW DAM/REAR WINDOW
UPPER MOLDING/REAR WINDOW GLASS
INSTALLATION
1. When replacing the rear window glass, first align it with
the body, and then matchmark them.
2. Use isopropyl alcohol to clean the inside edge of the
rear window glass and the body flange.
3. Use a primer dampened sponge to apply the primer to
the specified area around the rear window glass and
the body evenly.
4. After applying the primer, let it dry for at least 3 minutes.
Caution
(1) The primer strengthens the adhesive effect, so
that be sure to apply it. However, a too thick
application will weaken the adhesive effect.
(2) Never touch the primer-applied surface.
5. Position the glass stopper and the window dam in the
specified position, ensuring that there are no bends or
warpages inside the rear window glass.
42-17