Mitsubishi Electric Lancer Evolution-VII Workshop Manual page 589

52B-58
SRS warning lamp
SRS - Air Bag Modules and Clock Spring
"CA STEERING WHEEL/STEERING WHEEL - AIR BAG
1. After checking that centering of the clock spring has been
done, install the steering wheel or the steering wheel - air
bag module assembly.
Caution
Do not engage the harness of the clock spring when
installing the steering wheel or the steering wheel - air
bag module assembly.
2. After installation, check that no abnormalities occur when
the steering wheel is fully turned to the left or the right.
"DA POST-INSTALLATION INSPECTION
1. Check that no abnormal noise or improper operation can
be caused by rotating the steering wheel in left and right
directions slightly.
2. Turn the ignition switch to the ON position.
3. Check that the SRS warning lamp illuminates for 6 to
8 seconds and goes out.
4. Carry out troubleshooting if the lamp does not go out.
MODULE ASSEMBLY INSTALLATION
(driver's air bag module, clock spring)
(Refer to P.52-6.)