Mitsubishi Electric Lancer Evolution-VII Workshop Manual page 862

REAR AXLE -
MB990938
MB990935
MB990938
MB990932
MB990836
(MB990835)
MB990836
MB990685
Differential Carrier <Vehicles with mechanical LSD>
"BA DRIVE PINION REAR BEARING OUTER RACE
PRESS-FITTING
"CA DRIVE PINION FRONT BEARING OUTER RACE
PRESS-FITTING
"DA DRIVE PINION HEIGHT ADJUSTMENT
Adjust the drive pinion height by the following procedures:
1. Apply multipurpose grease to the washer of special tool.
2. Install special tool and drive pinion front and rear bearing
inner races to the gear carrier in the sequence shown
in the illustration.
3. Tighten the nut of special tool a little at a time while
measuring the turning torque of the drive pinion. Then
confirm the turning torque (without the oil seal) is at the
standard value.
Standard value:
Bearing type
New
Caution
Take care not to fit gear oil on the bearing.
NOTE
The special tool can not rotate, move several times in
MB990326
moving area, after rotating the bearing, measure the
torque.
MB990836
27B-45
Turning torque
0.88 - 1.17 N m
·