Mitsubishi Electric Lancer Evolution-VII Workshop Manual page 648

10 mm
15 mm
BODY -
Window Glass
6. Install the windshield molding.
7. Within thirty minutes after the primer application, fill a
sealant gun with the adhesive, and then apply the
adhesive evenly around the windshield.
NOTE
Cut the tip of the sealant gun nozzle into a V shape
to simplify adhesive application.
8. After applying adhesive, align the mating marks on the
windshield and the body, and then lightly press the
windshield evenly so that it adheres completely.
9. After removing any adhesive that is sticking out or adhering
to the windshield or body with spatula, etc., clean with
isopropyl alcohol. Install the windshield molding before
the adhesive sets. After the windshield is installed, wait
until the adhesive sets.
10. Adhere the windshield to the body, and install the roof
drip molding (Refer to GROUP 51.) promptly before the
adhesive sets.
11. After adhering the windshield to the body, wait 30 minutes
or more, and then test for water leakage.
Caution
(1) Move the vehicle carefully.
(2) When testing for water leakage, do not pinch the
end of the hose to spray the water.
42-15