Mitsubishi Electric Lancer Evolution-VII Workshop Manual page 629

51-22
(5) RECARO decal <RS - II>
<Right>
Stationary
window glass
15 mm
<Left>
Application tape terminal
19 mm
16 mm
EXTERIOR -
Application tape terminal
52 mm
RECARO decal terminal
Stationary window
weather strip terminal
2. Installation steps
(1) Remove grease on the marked surface of the
(2) Peel off the protection sheet on the back of the
Caution
1) Carry out the operation in a dust-free place where
2) If the room temperature is below 20, heat the mark
3) Be sure to pressure the mark immediately after
Marks
RECARO decal terminal
Stationary window
weather strip terminal
52 mm
body with unlead gasoline.
mark to paste it on the installation position.
the room temperature is between 20 and 38.
and the body (pasted area) between 20 and 30.
the pasting is done.
31 mm
16 mm
Stationary
window glass
28 mm