37A-18
STEERING - Power Steering Gear Box and Linkage
TIE ROD SWING RESISTANCE CHECK
1. Swing the tie rod 10 times hardly.
2. With the tie rod end downwards as shown, use a spring
scale to measure swing resistance (swing torque).
Standard value: 8 - 27 N (1.5 - 4.9 N·m)
3. If the measured value is above the standard value, replace
the tie rod.
4. If below, check the ball joint for looseness or ratcheting.
The tie rod is still serviceable when the ball joint swings
smoothly.
TIE ROD END BALL JOINT DUST COVER CHECK
1. Check the dust cover for cracks or damage by pushing
it with finger.
2. If the dust cover is cracked or damaged, replace the
tie rod end. (Refer to P.37A-19, 20.)
NOTE
A cracked or damaged dust cover may damage the ball
joint. Replace the dust cover when it is damaged during
service work.