INSPECTION CHART FOR DIAGNOSIS CODE
Diagnosis
Diagnosis items
code No.
12
Power supply voltage (valve power supply) system
13
Failsafe relay system <inside of 4WD-ECU>
21
FR wheel speed sensor system
22
FL wheel speed sensor system
23
RR wheel speed sensor system
24
RL wheel speed sensor system
25
Wrong-diameter tire
26
Wheel speed sensor (faulty output signal)
31
Steer sensor (ST-1, ST-2, ST-N) system
32
Steer sensor (ST-N) system
33
34
Steer sensor (ST-1, ST-2) system
41
TPS system
42
45
Pressure sensor system
46
47
51
G sensor (longitudinal) system
52
56
G sensor (lateral) system
57
REAR AXLE -
Troubleshooting <AYC>
ERASING THE DIAGNOSIS CODES
Connect the MUT-II to the 16-pin diagnosis connector and
erase the diagnosis code. (Refer to GROUP 00 – How to
Use Troubleshooting/Inspection Service Points.)
Caution
Turn the ignition switch to the LOCK (OFF) position before
connecting or disconnecting the MUT-II.
open- or short-circuit
open- or short-circuit
open- or short-circuit
open- or short-circuit
open- or short-circuit
open- or short-circuit
open- or short-circuit
short-circuit
fixed
short-circuit
or
output
fixed
open-circuit or ground
short-circuit
open-circuit or ground
open earth
abnormal power supply
open- or short-circuit
defective sensor
open- or short-circuit
defective sensor
27B-9
Reference page
Refer to
GROUP 22.
GROUP 22