Mitsubishi Electric Lancer Evolution-VII Workshop Manual page 592

SEAT BELT WITH PRE-TENSIONER
Caution:
1. Wait for at least
disconnecting the negative ( - ) terminal of
the battery before starting any operation.The
removed negative ( - ) terminal must be
protected by wrapping the tape. (Refer to
P.52B-3.)
2. Never disassemble or repair the seat belt
with pre-tensioner. Replace the part with a
new one when it malfunctions.
3. Take an extra care to deal with the seat belt
with pre-tensioner by avoiding dropping or
wetting it with water or oil. If any dent, crack,
or deformation is found, be sure to replace
the seat belt with pre-tensioner with a new
part.
REMOVAL AND INSTALLATION
Pre - removal operation
D Turn the ignition key to the LOCK(OFF) position.
D Disconnect the negative (- ) terminal of the battery.
Removal steps
1. Sash cover guide
2. Seat belt lower anchor bolt
3. Bracket
4. Seat belt shoulder anchor bolt
Center pillar lower trim
D
(Refer to GROUP 52A - Trim.)
5. Seat belt pre-tensioner
S RS - Seat Belt with Pre-tensioner
60 seconds after
3
44 ± 10 NSm
4. Do not place a heavy object on top of the
seat belt pre-tensioner.
5. Never keep the seat belt with pre-tensioner
in a place where the temperature can exceed
over 90_C.
6. Replace the seat belt with pre-tensioner with
a new one after operating the seat belt
pre-tensioner.
7. Wear gloves or protective glasses when
handling the seat belt with pre-tensioner
after operation.
8. If the seat belt with pre-tensioner before
operation needs to be discarded, be sure
to do so after operating the seat belt
pre-tensioner. (Refer to P.52B-64.)
4
44 ± 10 NSm
1
2
5
Installation steps
"AA
D
5. Seat belt pre-tensioner
4. Seat belt shoulder anchor bolt
3. Bracket
2. Seat belt lower anchor bolt
D
1. Sash cover guide
D
BA
"
D
Pre - installation inspection
Center pillar lower trim
(Refer to GROUP 52A - Trim.)
Negative ( - ) terminal of the battery
connection
Post - installation inspection
52B-61