Mitsubishi Electric Lancer Evolution-VII Workshop Manual page 780

WHEEL SPEED SENSOR
REMOVAL AND INSTALLATION
Caution
If the vehicle is equipped with the Brembo disc brake, during maintenance, take care not to contact
the parts or tools to the caliper because the paint of caliper will be scratched. And if there is
brake fluid on the caliper, wipe out quickly.
Post-installation Operation
Wheel Speed Sensor Output Voltage Check
(Refer to P.35B-26.)
<FRONT>
2
Removal steps
AA" "AA 1. Wheel speed sensor
2. ABS rotor
(Refer to GROUP 26/27 - Drive Shaft.)
<FRONT>
ABS <4WD> -
25 ± 6 N·m
25 ± 6 N·m
REMOVAL SERVICE POINT
AA" WHEEL SPEED SENSOR REMOVAL
Caution
Do not strike the pole piece at the tip of the wheel speed
sensor against the ABS rotor tooth surface or other parts
when removing the wheel speed sensor.
<REAR>
Wheel Speed Sensor
1
<REAR>
1
NOTE
The ABS rotors are integrated with the drive shaft
and cannot be disassembled.
35B-33
25 ± 6 N·m
2