Mitsubishi Electric Lancer Evolution-VII Workshop Manual page 863

27B-46
REAR AXLE -
MB990392
(MB990835)
A
MB990836
Thickness
(MB990835)
gauge
B
Drive pinion
rear shim
186 ± 29 N·m
MB990850
Differential Carrier <Vehicles with mechanical LSD>
4. Clean the side bearing hub.
Notch
5. Place special tool between the side bearing hub of the
6. Use a thickness gauge to measure the clearance (A)
7. Remove special tools (MB990835, MB990326).
8. Use a micrometer to measure the shown dimensions (B,
C
9. Install the bearing cap, and then use a cylinder gauge
10. Calculate thickness (F) of the required drive pinion rear
Cylinder
gauge
11. Fit the selected drive pinion rear shim(s) to the drive
MB990728
"EA DRIVE PINION TURNING TORQUE ADJUSTMENT
1. Insert the drive pinion into the gear carrier, and then install
2. Tighten the companion flange to the specified torque by
gear carrier, and position the notch as shown in the
illustration. Then tighten side bearing mounting bolt.
between special tools.
C) of special tools.
to measure inside diameter (D) of the bearing cap.
shim twice by the following formula. Select a shim which
most closely matches this thickness.
F = A + B + C - 1/2D - 86.00 mm
pinion, and press-fit the drive pinion rear bearing inner
race by using special tool.
/OIL SEAL INSTALLATION
the following parts in sequence from the carrier rear side.
Drive pinion spacer, drive pinion front shim and drive
pinion front bearing inner race, companion flange.
NOTE
Do not install the oil seal.
using special tool.