Mitsubishi Electric Lancer Evolution-VII Workshop Manual page 546

From Previous Page
YES
<Check the circuit between the SRS-ECU and clock
spring>
Measure at the SRS-ECU connector C- 21 .
D Disconnect the SRS-ECU connector C-21.
D Release the the clock spring connector C-204.
Caution
Disconnect the connector and short-circuit the squib
circuit before releasing the short bar of the SRS-ECU
connector in the following operation.
D Cable bands between terminals 11, 12 and the short bar
(width:3 mm, thickness:0.5 mm) between terminals 11 and
12 and the short bar, and release the short bar.
(See Figure A.)
Caution
As the short bar may not be releasable if inserted
insufficiently, insert more than 4 mm.
D Measure at the harness side
D Continuity check between terminals 11 and 12
Caution
Do not directly insert a probe or other devices at the
front of the connector to avoid a possible decrease in
the contact pressure.
OK: No continuity
Connector C-21
OK
Replace the SRS-ECU.
SRS -
Troubleshooting
NG
Check connector: C- 21, C-204
Check the trouble
symptoms.
Check the harness between the clock spring and the
SRS-ECU, and repair if necessary.
Figure A
Section
A - A
OK
NG
Front view of SRS-ECU
connector C-21
(harness side)
Terminal
Cable band and etc.
A
A
Short bar
4 mm or more
52B-15
NG
Correct