Hub And Knuckle Assembly - Mitsubishi Electric Lancer Evolution-VII Workshop Manual

MB991113
MB990635
Nut
Ball joint
MB990767
MB991354
MB990242
FRONT AXLE -

Hub and Knuckle Assembly

REMOVAL SERVICE POINTS
AA" CALIPER ASSEMBLY REMOVAL
Secure the removed caliper assembly with wire, etc.
Caution
If the vehicle is equipped with the Brembo disc brake,
during maintenance, take care not to contact the parts
or tools to the caliper because the paint of caliper will
be scratched. And if there is brake fluid on the caliper,
wipe out quickly.
AB" CASTLE NUT REMOVAL
Caution
Do not apply the vehicle weight to the wheel bearing
while loosening the castle nut. Otherwise wheel bearing
will be damaged.
MB990767
AC" TIE ROD END DISCONNECTION
or
Caution
1. Loosen the nut only; do not remove it from the ball
2. The special tool should be suspended by a cord to
Cord
AD" DRIVE SHAFT REMOVAL
1. Use the special tools to push out the drive shaft from
MB990244
(Three)
2. Withdraw the drive shaft from the hub by pulling the bottom
joint. Otherwise ball joint thread will be damaged.
prevent it from coming off.
the hub.
of the brake disc towards you, and then remove the hub
retaining bolts.
26-7