Mitsubishi Electric Lancer Evolution-VII Workshop Manual page 666

MB990480
Door center sash
<FRONT DOOR>
1
7
3
2
6
<REAR DOOR>
1
4
3
2
5
BODY -
REMOVAL SERVICE POINTS
AA" WINDOW REGULATOR ASSEMBLY/POWER
1. Loosen the door window glass assembly mounting bolts.
2. Raise the door window glass assembly, and then adhere
3. Remove the power window regulator and motor assembly.
AB" DOOR CENTER SASH REMOVAL
1. Remove only the section of the door outer opening
2. Remove the center sash upper mounting screws, and
Door outer opening
weatherstrip
A18X0127
INSTALLATION SERVICE POINTS
"AA WINDOW REGULATOR ASSEMBLY/POWER
When installing the window regulator assembly, tighten he
4
bolts at the specified torque in the order shown in the
illustration.
5
6
Doors
WINDOW MOTOR ASSEMBLY REMOVAL
the special tool on the glass as shown in the illustration
to prevent from falling.
CautionFor the door window glass adhered film and
etc., use the special tool from outside the door glass
to prevent unstucking.
weatherstrip
then remove the center sash upper from the door panel.
WINDOW MOTOR ASSEMBLY INSTALLATION
42-33