Removal And Installation - Mitsubishi Electric Lancer Evolution-VII Workshop Manual

HEATER, AIR CONDITIONER AND VENTILATION
HEATER CONTROL ASSEMBLY (A/C-ECU) AND A/C SWITCH

REMOVAL AND INSTALLATION

3
4
5
Removal steps
"BA 1. Air mix door cable connection
"AA 2. Blow vent switching damper cable con-
nection
3. Temperature adjustment knob
<R.H. drive vehicles>
Mold locator
DEF position
<L.H. drive vehicles>
Blow vent switching
damper lever
DEF position
6
INSTALLATION SERVICE POINTS
"AA BLOW VENT SWITCHING DAMPER CABLE
1. Set the heater control assembly's blow vent switching
knob to the DEF position.
2. Set the heater unit's blow vent switching damper lever
Blow vent
to the DEF position (turn the damper lever as the left
switching
damper lever
sketch.) and install the cable.
3. Set the I type postion of cable to the heater unit case
and secure with a clip.
Mold locator
Heater Control Assembly
-
(A/C-ECU) and A/C Switch
1
2
7
4. Air volume adjustment knob
5. Blow vent switching knob
6. Center panel
7. Control panel assembly
CONNECTION
55-25