Mitsubishi Electric Lancer Evolution-VII Workshop Manual page 33

C-16
WELDED PANEL REPLACEMENT -
Quarter, Outer
<The following service procedures are only applied to
RS-II.>
2. After attaching the quarter outer, seal the holes and
flanges with bolts and plate tape, and fill foam material from
hole shown in the illustration.
Foam material Type
Foam acoustic Two-part expanded
material wretane
3. After two hours after filling the foam material, remove
the bolts and plate tape, and solder the sealed holes
until a clip, etc. can be inserted completely.
Reference
Parts replacement is advised. depending on the damaged
range.
: Cuttable range
Caution
Avoid the fuel filler bracket (left side).
Brand Used
3M ULTRAPRO
Panel foam - Yellow