Mitsubishi Electric Lancer Evolution-VII Workshop Manual page 562

From Previous Page
NG
<Check the circuit between the SRS-ECU and the junction
block>
Measure at the SRS - ECU connector C-21.
D Disconnect the SRS-ECU connector C-21 and measure at
the harness side.
D Continuity check between terminal 16 and body earth
Caution
Do not directly insert a probe or other devices at the
front of the connector to avoid a possible decrease in
the contact pressure.
OK: No continuity
OK
Replace the SRS-ECU.
SRS -
Troubleshooting
Connector C-41
NG
Check the harness between the SRS-ECU and junction block,
and repair if necessary.
52B-31