Mitsubishi Electric Lancer Evolution-VII Workshop Manual page 752

ABS warning lamp
Approx. 3 s
ABS
Illuminated
warn-
ing Not
illuminated
lamp
START
Ignition
ON
switch
ACC,
ABS <4WD> -
ABS WARNING LAMP INSPECTION
Check that the ABS warning lamp illuminates as follows.
1. When the ignition key is turned to "ON", the ABS warning
lamp illuminates for approximately 3 seconds and then
switches off.
2. When the ignition key is turned to "START", the ABS
warning lamp remains illuminated.
3. When the ignition key is turned from "START" back to
"ON", the ABS warning lamp illuminates for approximately
3 seconds and then switches off.
NOTE
The ABS warning lamp may remain on until the vehicle
reaches a speed of several km/h. This is limited to cases
Approx. 3 s
where diagnosis code Nos.21 to 24, 41 to 44, 53 or 55
have been recorded because of a previous problem
occurring. In this case, the ABS-ECU keeps the warning
lamp illuminated until the problem corresponding to that
diagnosis code can be detected.
4. If the illumination is other than the above, check the
diagnosis codes.
DIAGNOSIS FUNCTION
READING DIAGNOSIS CODES
Read a diagnosis code by the MUT-II or ABS warning lamp.
(Refer to GROUP 00 - How to Use Troubleshooting/Inspection
Service Points.)
NOTE
Connect the MUT-II to the diagnosis connector (16-pin).
ERASING DIAGNOSIS CODES
When using the MUT-II
Connect the MUT-II to the diagnosis connector (16-pin) and
erase the diagnosis code.
Caution
Turn the ignition key to the "LOCK" (OFF) position before
connecting or disconnecting the MUT-II.
Troubleshooting
35B-5