Mitsubishi Electric Lancer Evolution-VII Workshop Manual page 602

Steering wheel - driver's air bag
module assembly
Insulation tape
Short-circuited area
Steering wheel - driver's air bag module assembly
Deployment
harness
Tyres without wheels
Deployment harnesses
Deployment harnesses
Air Bag Module and Seat Belt Pre-tensioner
SRS -
Disposal Procedures
(4) Release the secured connector of the steering
Deployment
harness
(5) Use a rope to tie the steering wheel - driver's air bag
(6) Route the deployment harness connected to driver's
(7) Place three old tyres without wheels on the tyre
(8) Separate the deployment harnesses as far from the
(9) Discard the deployed air bag module as specified
wheel - driver's air bag module assembly to cut off
the connector from the harness with a nipper and
etc. Connect deployment harnesses to each of two
separated harnesses and cover the area with
insulation tape.
module assembly to secure old tyres with wheels.
air bag module beneath old tyres with wheels. Then,
secure the steering wheel - driver's air bag module
assembly with the deployment surface facing up.
secured with the driver's air bag module.
driver's side air bag module as possible and connect
to the terminals of the battery removed from the
vehicle. Then deploy.
Caution
1) Before the deployment, see that no one is near
around the driver's air bag module.
2) The deployment makes the inflator of the
driver's air bag very hot. Before handling the
inflator, wait more than 30 minutes for cooling.
3) If the driver's air bag module fails to deploy
although the procedure is respected, do not go
near the module.
distributor.
in Deployed Air Bag Module Disposal Procedures.
(Refer to P.52B-75.)
52B-71
Contact your local