Intercept Routing-No Destination - Panasonic KX-TAW848 Features Manual

1.1 Incoming Call Features
b)
c)
• If the intercept destination can, but does not, answer the call:
The call continues to ring at the intercept destination until answered.
• Intercept Routing—Busy/DND on/off
Intercept Routing—Busy and Intercept Routing—DND can each be enabled or disabled
for the entire system, through system programming. If enabled, calls will be routed to the
appropriate destination.
If disabled, the caller will hear a ringback tone. If busy, the extension will not ring. If in DND
mode, the extension will ring.
• Idle Extension Hunting
If an extension is a member of an idle extension hunting group, calls to that extension will
not be redirected by Intercept Routing—Busy/DND. If the extension is busy or in DND
mode, calls to that extension will be redirected to the next extension in the idle extension
hunting group.
Feature Guide References
1.3.1 Call Forwarding (FWD)/Do Not Disturb (DND)
1.1.1.5 Intercept Routing—No Destination
Description
Directs a CO line call to an operator when the call has no assigned destination.
Conditions
• If an operator is not assigned:
The default intercept destination will be the extension connected to the lowest numbered
port, on the card installed in the lowest numbered slot.
• Intercept Routing—No Destination also applies to calls from doorphones.
Feature Guide References
2.2.5 Operator Features
18 Feature Guide
When the call was intercepted via Intercept Routing—Busy, the call waits at the
original destination. If the extension has Call Waiting activated, the user will hear a
call waiting tone.
When the call was intercepted via Intercept Routing—DND, the call waits at the
original destination and it rings.