Mitsubishi Electric GOT2000 Series Connection Manual page 864

■5. MELSERVO-J2S-*CP
Bit device
Word device
Double word device
*1
*2
*3
*4
15 - 42
15.6 Device Range that Can Be Set
*3
Device name
Servo amplifier request (SP)
Operation mode selection (OM)
Instruction demand(for test operation) (TMB)
Basic parameter/expansion parameter (PRM)
Status display (ST)
Alarm (AL)
*4
External input (DI)
External output (DO)
*2
Point table (position) (POS)
Point table Point table (speed) (SPD)
Point table (acceleration time constant) (ACT)
Point table (deceleration time constant) (DCT)
*2
Point table (dwell) (DWL)
Point table (auxiliary function) (AUX)
Input signal for test operation (for test operation) (TMI)
Forced output of signal pin (for test operation) (TMO)
Set data (for test operation) (TMD)
Use PRM0 to PRM90 when writing parameters to the servo amplifier RAM.
PRM1000 to PRM1090 are used when writing parameters to E
Use PRM1000 to PRM1090 when reading parameters to the servo amplifier RAM.
When writing to a point table, use the area of 1001 to 1031 (E
If writing to the area of 1 to 31 (RAM area) of POS, SPD, ACT, DCT, DWL, or AUX, the value is not reflected.
The GOT cannot read or write data from/to consecutive devices.
Only reading is possible for DI0 to DI1.
POINT POINT POINT
Precautions for SP, OM, TMB, TMI, TMO, and TMD devices
(1) For bit devices
Only writing is possible.
[Alternate] of a bit switch cannot be used.
Use [Set], [Reset], and [Momentary] of a bit switch.
(2) For word devices, double word devices
Only writing is possible.
Numerical input cannot be used.
When writing, use [Word Set] of a data set switch.
SP0 to SP6
OM0 to OM4
TMB0 to TMB1
PRM0 to PRM90
*1
PRM1000 to PRM1090
ST0 to ST16
AL0 to AL1
AL11 to AL27
AL200 to AL205
AL210 to AL215
AL230 to AL235
DI0 to DI2
DO0 to DO1
POS1 to POS31
POS1001 to POS1031
SPD1 to SPD31
*2
SPD1001 to SPD1031
ACT1 to ACT31
*2
ACT1001 to ACT1031
DCT1 to DCT31
*2
DCT1001 to DCT1031
DWL1 to DWL31
DWL1001 to DWL1031
AUX1 to AUX31
*2
AUX1001 to AUX1031
TMI0
TMO0
TMD0 to TMD2
2
PROM of the servo amplifier.
2
PROM area) of POS, SPD, ACT, DCT, DWL, or AUX.
Setting range
Device No.
representation
Decimal