Mitsubishi Electric GOT2000 Series Connection Manual page 603

POINT POINT POINT
Routing parameter setting of request source
Routing parameter setting is also necessary for the request source GOT.
For the setting, refer to the following.
(2) [Controller Setting] of GT Designer3
Network type
Network No.
Station No.
Group No.
Mode
Refresh Interval
Retry
Timeout Time
Delay Time
Monitor Speed
POINT POINT POINT
Network type of the GOT side
When the network is in the extended mode, be sure to set the network type of the GOT side to
[CC IE Control extended mode].
For [Controller Setting], of GT Designer3, refer to the following.
➠ 10.3.3 Routing parameter setting
Item
➠ 10.3.1 Setting communication interface (Controller Setting)
Set value
CC IE Control extended mode
1: Network No.1
2: Station No.2
0 (fixed)
Online (auto. reconnection)
1ms (Use default value)
3times (Use default value)
3sec (Use default value)
0ms (Use default value)
High (Normal) (Use default value)
10.4 PLC Side Setting
10
10 - 25