Mitsubishi Electric GOT2000 Series Connection Manual page 307

Item
Transient Transmission Group No.
Online Program Change Permission/Protection Setting
Communication Data Code
Open Method Setting
Target Device Connection Configuration Setting
*2 Set the same network No. as that of the GOT.
*3 Do not set the same station No. as that of the GOT.
(2) Target Device connection Configuration Setting
Protocol
Open system
Host station port No.
POINT POINT POINT
When changing the module parameter
After writing module parameters to the PLC CPU, turn the PLC CPU OFF then back ON again, or
reset the PLC CPU.
(3) Routing setting
Up to 238 [Target Station Network No.]s can be set.
However, the same target station network number cannot be set twice or more (multiple times).
Therefore, the one that can access to other station from the request source host GOT is 238 kinds of [Target Station
Network No.]s.
Target Station network No.
Relay Station network No.
Item
Item
Set value
(Use default value)
Refer to (2).
: Necessary : As necessary
Set value
(Use default value)
MELSOFT connection (fixed)
(Use default value)
Range
1 to 239
1 to 239
5.4 PLC Side Setting
Setting necessity at GOT
connection
: Not necessary
5 - 41
5