Mitsubishi Electric GOT2000 Series Connection Manual page 203


When setting the IP address, Network No., and station number separately
Set [Communications by Network No./Station No.] to [Enable] and [Setting Method] to [Not Use IP Address],
and set the IP address, network number, and station number separately.
(1) In the system configuration example, the values are as follows.
IP Address: 192.168.0.1
Network No.: 2
Station No.: 1
(4) GOT Side Settings
Set GT Designer3 as follows.
Setting item
Controller Type
Routing Information
Device setting (Network setting)
MELSEC Redundant Setting
(5) Monitoring target change when system switching occurs in a redundant system
When the system switching occurs, CPU (Network No.: 1, PLC station No.: 1) takes over the control of the Ethernet
network system as the control system.
The GOT automatically starts monitoring accroding to the specified system.
MELSEC iQ-R, RnMT/NC
➠
5. ETHERNET CONNECTION
Host
Network No. 1
Other
Station No.: 0
The system (control system/standby system) of the the monitor target can
be speified.
Control system/
Only when checking [Enable Redundant Function] in the following
standby system
[MELSEC Redundant System Setting], [Control System/Standby System]
can be set.
➠
4.3 MELSEC Redundant Setting
Contents of setting
-
4.1 MELSEC iQ-R Series
4
Model
4 - 27