1.5
Verifying GOT Recognizes Connected Equipment
Verify the GOT recognizes controllers on [Communication Settings] of the Utility.
• Channel number of communication interface, communication drivers allocation status
• Communication unit installation status
For details on the Utility, refer to the following manual.
➠
GOT2000 Series User's Manual (Utility)
Step 1.
After powering up the GOT, touch [GOT basic set]
Step 2.
The [Communication Settings] appears.
Step 3.
Verify that the communication driver name to be used is displayed in the communication interface box to be
used.
Step 4.
When the communication driver name is not displayed normally, carry out the following procedure again.
➠
1.1Setting the Communication Interface
1.
2.
1.5 Verifying GOT Recognizes Connected Equipment
[Controller] from the Utility.
3.
1
1 - 37