■2. [Module parameter] of GX Works3
(1) Built-in Ethernet port
Item
IP Address
Subnet Mask
Default Gateway
Communication Data Code
Target Device Connection Configuration
Setting
(2) Target Device connection Configuration Setting
The setting is required for all the connected GOTs
*1
Even if the target device connection configuration setting is not executed, 1 GOT can be connected. When connecting to the PLC
in Ethernet connection with programming tools such as GX Works3, these programming tools and PLC may not be connected. In
this case, the setting is required for all the GOTs.
Protocol
Open system
Host station port No.
Set value
192.168.3.250
(Use default value)
(Use default value)
➠
(2) Target Device connection
Configuration Setting
*1
.
Item
Setting necessity at GOT connection
-
-
○: Necessary
: As necessary ×: Not necessary
Set value
(Use default value)
MELSOFT connection (fixed)
(Use default value)
5.4 PLC Side Setting
5
×
×
○
5 - 49