Mitsubishi Electric GOT2000 Series Connection Manual page 890

■9. MELSERVO-J4-*A, -JE-*A
Bit device
Word device
Double word device
*1
*2
*3
*4
*5
*6
15 - 68
15.6 Device Range that Can Be Set
*2
Device name
Servo amplifier request (SP)
Operation mode selection (OM)
Instruction demand (for test operation) (TMB)
One-touch tuning command (OTI)
*1
Basic setting parameter (PA)
*1
Gain filter parameter (PB)
Extension setting parameter (PC)
*1
I/O setting parameter (PD)
Extension setting 2 parameter (PE)
Extension setting 3 parameter (PF)
Linear servo motor/DD motor setting parameter (PL)
*3
Status display (ST)
*3
Alarm (AL)
*3
Alarm (ALM)
Machine diagnosis data (MD)
One-touch tuning data (OTS)
*4
External input (DI)
*3
External output (DO)
*3
Lifetime diagnosis (ALD)
Input signal for test operation (for test operation) (TM0)
Forced output of signal pin (for test operation) (TMO)
Set data (for test operation) (TMD)
Use 1 to 80 of PA, PB, PC, PD, PE, PL and PF when the GOT writes data to RAM of the servo amplifier.
Use 1001 to 1080 of PA, PB, PC, PD, PE, PF and PL when the GOT write data to E
Use PA, PB, PC, PD, PE, PF, PL 1001 to 1080 when reading parameters to the servo amplifier RAM.
The GOT cannot read or write data from/to consecutive devices.
Only reading is possible.
Only reading is possible for DI0 to DI1.
Only writing is possible.
These devices cannot be used for MELSERVO-JE
SP0 to SP6
OM0 to OM2
OM4
TMB1 to TMB6
*5
OTI0 to OTI5
PA1 to PA32
PA1001 to PA1032
PB1 to PB64
PB1001 to PB1064
PC1 to PC80
*1
PC1001 to PC1080
PD1 to PD48
PD1001 to PD1048
PE1 to PE64
*1
PE1001 to PE1064
PF1 to PF48
*1
PF1001 to PF1048
PL1 to PL48
*2*6
PL1001 to PL1048
ST0 to ST41
AL0 to AL1
AL11 to AL25
AL200 to AL205
AL210 to AL215
AL230 to AL235
ALM0 to ALM1
ALM11 to ALM52
ALM200 to ALM215
ALM220 to ALM235
ALM240 to ALM255
*3
MD0 to MD11
*3
OTS0 to OTS3
DI0 to DI2
DO0 to DO1
ALD0 to ALD1
TMI0
TMO0
TMD0 to TMD1
TMD3
Setting range
2
PROM of the servo amplifier.
Device No.
represen tation
Decimal