Mitsubishi Electric GOT2000 Series Connection Manual page 707

■3. Sequence program
The parameter setting and the sequence program of the data link startup request is required.
(1) Programming condition (with CC-Link dedicated instructions)
The program sets the network parameter and automatic refresh parameter when PLC CPU status changes from
STOP to RUN, and automatically starts the data link with CC-Link dedicated instructions.
(a) I/O signal of CC-Link module
➠
Control & Communication Link System Master/Local Module Type AJ61BT11/A1SJ61BT11
User's Manual
(b) Device used by user
D100 to D103
D104 to D107
D108 to D111
D112 to D115
D116 to D119
Device
M0 RLPA instruction normal completion flag
M1 RLPA instruction error completion flag
M100 Network parameter setting flag
M101 Automatic refresh parameter setting flag
D0 Synchronous mode valid/invalid
D1 Number of connected modules
D2 Station data
D3 Send buffer size
D4 Receive buffer size
D5 Automatic update buffer size
D400 Error code in the case of error completion of RLPA instruction
Automatic refresh setting (RX)
Automatic refresh setting (RY)
Automatic refresh setting (RW)
Automatic refresh setting (SB)
Automatic refresh setting (SW)
Application
12.4 PLC Side Setting
12
12 - 65