Mitsubishi Electric GOT2000 Series Connection Manual page 296

Delay Time
(b) GOT Standard Ethernet Setting
GOT IP Address
Subnet Mask
Default Gateway
Peripheral Communication Port No.
Transparent Port No.
(c) Ethernet setting
Ethernet setting No.1
*1 Set the same value as that of GOT N/W No.
*2 Set a value different from that of GOT PLC No.
*3 In the case of CNC C80(R16NCCPU-S1), set to [RnNCCPU].
(3) Checking communication state of Built-in Ethernet port CPU
(a) When using the Command Prompt of Windows.
Execute a Ping command at the Command Prompt of Windows.
1) When normal communication
C:\>Ping 192.168.3.39
Reply from 192.168.3.39: bytes=32 time
<10ms TTL=32
2) When abnormal communication
C:\>Ping 192.168.3.39
Request timed out.
(b) When abnormal communication
At abnormal communication, check the following and execute the Ping command again.
• Cable connecting condition
• Confirmation of switch and network parameter setting
• Operation state of PLC CPU (faulty or not)
• The IP address of Built-in Ethernet port CPU specified in the ping command
5 - 30
5.4 PLC Side Setting
Item
Item
Item
Host
N/W No.
PLC No.
Type
IP Address
Port No.
Communication
POINT POINT POINT
Ethernet diagnostics of GX Works3
Ethernet diagnostics of GX Works3 is available to a Ping test from the PLC.
For details of Ethernet diagnostics of GX Works3, refer to the following manual.
➠ Manuals of MELSEC iQ-R Series
Set value (Use default value)
0ms
Set value (Use default value)
192.168.3.18
255.255.255.0
0.0.0.0
5015
5014
Set value
*
*1
1
*2
2
*3
RCPU
192.168.3.39
5006
UDP