Siemens SINAMICS S120 Function Manual page 564

Hide thumbs Also See for SINAMICS S120:

Table of Contents

Basic information about the drive system

12.1 Parameter

The CDS and DDS can be switched over during normal operation. Further types of data set

also exist, however these can only be activated indirectly by means of a DDS changeover.

● EDS Encoder Data Set

● MDS Motor Data Set

Saving parameters in a non-volatile memory

The modified parameter values are stored in the volatile RAM. When the drive system is

switched off, these data are lost.

The data must be saved retentively on the memory card, as described below, so that it is

available the next time the drive is switched on.

Parameter categories

Function Manual, (FH1), 10/2008, 6SL3097-2AB00-0BP5

Drive functions