Measuring variants
3.2 Measure workpiece (turning)
ShopMill program
Parameter
β
Z
X
List of the result parameters
The measuring variant "Outside diameter" provides the following result parameters:
Table 3-8
Parameters
_OVR [0]
_OVR [1]
_OVR [2]
_OVR [3]
_OVR [4]
_OVR [5]
_OVR [6]
_OVR [7]
_OVR [16]
_OVR [17]
_OVR [18]
_OVR [19]
_OVI [0]
_OVI [2]
For workpiece measurement with tool offset or correction in the work offset, additional
parameters are displayed, seeAdditional result parameters (Page 342).
104
Description
Tool alignment with swivel axis
●
(0 degrees)
●
(90 degrees)
● Value input
Start point Z of the measurement
Start point X of the measurement
"Outside diameter" result parameters
Description
Diameter setpoint (note measuring axis S_MA)
Diameter setpoint in 1st axis of the plane → only for S_MA=1
Diameter setpoint in 2nd axis of the plane → only for S_MA=2
Diameter setpoint in 3rd axis of the plane → only for S_MA=3
Diameter actual value
Diameter actual value in 1st axis of the plane → only for S_MA=1
Diameter actual value in 2nd axis of the plane → only for S_MA=2
Diameter actual value in 3rd axis of the plane → only for S_MA=3
Diameter difference
Diameter difference in 1st axis of the plane → only for S_MA=1
Diameter difference in 2nd axis of the plane → only for S_MA=2
Diameter difference in 3rd axis of the plane → only for S_MA=3
D number
Measuring cycle number
Programming Manual, 12/2017, 6FC5398-4BP40-6BA1
Unit
Degrees
mm
mm
Unit
mm
mm
mm
mm
mm
mm
mm
mm
mm
mm
mm
mm
-
-
Measuring cycles