Siemens SINUMERIK 840D sl Programming Manual page 347

A.1 Assignment of the measuring cycle parameters to MEA_FUNCTION_MASK parameters
Bit Function
1)
6 Activate/deactivate workpiece probe before and after
the NC command SPOS.
See also CUST_MEA_CYC.SPF
(default = 0)
0 = No call CUST_MEA_CYC.SPF
1 = Call CUST_MEA_CYC.SPF
...
14 Coupling of the spindle position, with a coordinate ro‐
tation around the infeed axis when a measuring in AU‐
TOMATIC (default = 1)
15 Calibration in the calibration ring when measuring in
JOG
(default = 0)
0 = Calibrate with automatic reference center point
1 = Calibrate with known reference center point
Tool measurement
16 Collision monitoring (default = 1)
17 Measurement attempts when the probe does not
switch
(default = 0)
0 = 5 attempts
1 = 1 attempt
18 Approach velocity to the measuring position (default =
0)
0 = With measuring feedrate _VMS
1 = With $SCS_MEA_FEED_FAST_MEASURE
19 Retraction velocity from the measuring point (default =
0)
0 = With $SCS_MEA_FEED_PLANE_VALUE
1 = With $SCS_MEA_FEED_RAPID_IN_PERCENT
Bit x=0 means that the function is disabled
1)
Bit x=1 means that the function is enabled
All non-documented bits are not assigned.
Measuring cycles
Programming Manual, 12/2017, 6FC5398-4BP40-6BA1
Changes from cycle version SW4.4 and higher
MD identifier
SW 2.6
-
55770 $SCS_J_MEA_SET_COUPL_SP_CO‐
ORD
55771 $SCS_J_MEA_SET_CAL_MODE
55600 $SCS_MEA_COLLISION_MONITOR‐
ING
55606 $SCS_MEA_NUM_OF_MEASURE
55610 $SCS_MEA_FEED_TYP
55608 $SCS_MEA_RETRACTION_FEED
GUD name
up to SW 2.6
-
E_MESS_
SETT[0]
E_MESS_
SETT[1]
_CHBIT[2]
_CHBIT[15]
_CHBIT[17]
_CHBIT[16]
347