Siemens SINUMERIK 840D sl Programming Manual page 156

Measuring variants
3.3 Measure workpiece (milling)
Measuring variant, turning on a milling machine (only 840D sl)
Procedure
The part program or ShopTurn program to be edited has been created and you are in the editor.
Parameter
ShopTurn program
Parameter
T
D
X
Y
Z
List of the result parameters
The measuring variant "Right-angled corner" provides the following result parameters:
Table 3-18
Parameters
_OVR [4]
_OVR [5]
_OVR [6]
_OVR [20]
_OVR [21]
_OVR [22]
_OVI [2]
_OVI [3]
_OVI [5]
_OVI [9]
For deactivated transformation, otherwise basic coordinate system
1)
156
1. Press the "Meas. workp." softkey.
2. Press the "Corner" softkey.
3. Press the "Right-angled corner" softkey.
The input window "Measure: Right-angled corner" opens.
Description
Name of the probe
Cutting edge number (1 - 9)
Calibration data set (1 - 40)
Start point X of the measurement
Start point Y of the measurement
Start point Z of the measurement
"Right-angled corner" result parameters
Description
The actual angle value of the angle reference edge to be measured, rela‐
tive to the 1st geo-axis of the active plane in the workpiece coordinate
system (WCS).
Corner point actual value in the 1st axis of the plane in the WCS
Corner point actual value in the 2nd axis of the plane in the WCS
The actual angle value of the angle reference edge to be measured, rela‐
tive to the 1st geo-axis of the active plane in the machine coordinate sys‐
tem (WCS).
1)
Corner point actual value in the 1st axis of the plane in the MCS
Corner point actual value in the 2nd axis of the plane in the MCS
Measuring cycle number
Measuring version
Probe number
Alarm number
Programming Manual, 12/2017, 6FC5398-4BP40-6BA1
Unit
-
-
-
mm
mm
mm
Unit
Degrees
mm
mm
Degrees
mm
1)
mm
1)
-
-
-
-
Measuring cycles