Siemens SINUMERIK 840D sl Programming Manual page 341

Additional correction options when measuring workpiece:
1. Work offsets
– Offset in the basic reference
– Offset in the channel-specific basic WO
– Offset in the global basic WO
– Offset, coarse or fine
2. Tool offsets
– Tool offset in geometry or wear
– Tool offset, inverted or not inverted
– Tool offset in radius or length L1 or L2 or L3
Table 4-17 Supplementary parameter when measuring tool
Screen form pa‐ Transfer pa‐
rameters rameters
Calibration data set S_PRNUM
F
S_VMS
Selection, measur‐
S_MVAR
ing steps
Selection
S_MVAR
Selection
S_MVAR
Number
S_NMSP
Data set, empirical
S_EVNUM
values
Measuring cycles
Programming Manual, 12/2017, 6FC5398-4BP40-6BA1
Description
Number of the data set with the calibrated values of the probe
Measuring feedrate when calibrating the probe
Input of max. 3 feedrates and 3 spindle speeds when measuring with rotating
spindle
Tool offset in geometry or wear
Measurement in the machine coordinate system or workpiece coordinate
system
Number of measurements at the same location
Generating empirical values for correction in a tool
Parameter lists
4.2 Additional parameters
Unit
-
mm/min
-
-
-
-
-
341