Siemens SINUMERIK 840D sl Programming Manual page 182

Measuring variants
3.3 Measure workpiece (milling)
Parameter
G code program
Parameter Description
Measuring
● Standard measuring
method
method
● 3D probe with spindle
reversal
● Align 3D probe
PL Measuring plane (G17 - G19)
Calibration data set (1 - 40)
(only for measuring without
spindle reversal)
Parameter Description
Correction target
● Measuring only (no offset)
● Work offset (save measured values in a settable WO)
● Tool offset (save measured values in the tool data)
TR Name of tool to be corrected
D Cutting edge number of tool to be corrected
W Setpoint, spigot width
L Setpoint, spigot length
XM, YM The setpoint value specification for rectangular spigot center point (only for setpoint center
point "Yes")
α0 Contact angle
DZ Infeed distance at measuring height (for G17)
Protection zone Use protection zone
● Yes
● No
WS Width of the protection zone (only for protection zone "Yes")
LS Length of the protection zone (only for protection zone "Yes")
DFA Measurement path
TSA Safe area for the measurement result
182
Unit
-
1)
2)
-
-
4)
ShopMill program
Parameter Description
T Name of the probe
D Cutting edge number (1 - 9)
Measuring
● Standard measuring
method
method
● 3D probe with spindle
reversal
● Align 3D probe
Calibration data set (1 - 40)
(only for measuring without
spindle reversal)
X Start point X of the measure‐
ment
Y Start point Y of the measure‐
ment
Z Start point Z of the measure‐
ment
3)
Programming Manual, 12/2017, 6FC5398-4BP40-6BA1
Unit
-
-
-
1)
2)
-
mm
mm
mm
Unit
-
-
-
mm
mm
mm
Degrees
mm
-
mm
mm
mm
mm
Measuring cycles