Siemens SINUMERIK 840D sl Programming Manual page 178

Measuring variants
3.3 Measure workpiece (milling)
Parameter
ShopTurn program
Parameter
T
D
Measuring method
X
Y
Z
List of the result parameters
The measuring variant "Inner circle segment" provides the following result parameters:
Table 3-22
Parameters
_OVR [0]
_OVR [1]
_OVR [2]
_OVR [4]
_OVR [5]
_OVR [6]
_OVR [16]
_OVR [17]
_OVR [18]
_OVI [0]
_OVI [2]
_OVI [3]
_OVS_TNAME
178
1. Press the "Meas. workp." softkey.
2. Press the "Hole" softkey.
3. Press the "Inner circle segment" softkey.
The input window "Measure: Inner circle segment" opens.
Description
Name of the probe
Cutting edge number (1 - 9)
● Standard measuring method
● 3D probe with spindle reversal
● Align 3D probe
Calibration data set (1 - 40)
(only for measuring without spindle reversal)
Start point X of the measurement
Start point Y of the measurement
Start point Z of the measurement
"Inner circle segment" result parameters
Description
Hole diameter setpoint
Center point setpoint in the 1st axis of the plane
Center point setpoint in the 2nd axis of the plane
Hole diameter actual value
Center point actual value in the 1st axis of the plane
Center point actual value in the 2nd axis of the plane
Hole diameter difference
Center point difference in the 1st axis of the plane
Center point difference in the 2nd axis of the plane
D number or WO number
Measuring cycle number
Measuring variant
Tool name
1)
2)
Programming Manual, 12/2017, 6FC5398-4BP40-6BA1
Unit
-
-
-
-
mm
mm
mm
Unit
mm
mm
mm
mm
mm
mm
mm
mm
mm
-
-
-
-
Measuring cycles