Siemens SINUMERIK 840D sl Programming Manual page 199

Measuring variant, turning on a milling machine (only 840D sl)
Procedure
The part program or ShopTurn program to be edited has been created and you are in the editor.
Parameter
ShopTurn program
Parameter
T
D
X
Y
Z
List of the result parameters
The measuring variant "Align plane" provides the following result parameters:
Table 3-26
Parameters
_OVR [0]
_OVR [1]
_OVR [4]
_OVR [5]
_OVR [16]
_OVR [17]
_OVR [20]
_OVR [21]
Measuring cycles
Programming Manual, 12/2017, 6FC5398-4BP40-6BA1
Machine manufacturer
Please observe the information provided by the machine manufacturer.
1. Press the "Meas. workp." softkey.
2. Press the "3D" softkey.
3. Press the "Align plane" softkey.
The input window "Measure: Align plane" opens.
Description
Name of the probe
Cutting edge number (1 - 9)
Calibration data set (1 - 40)
Start point X of the measurement
Start point Y of the measurement
Start point Z of the measurement
"Align plane" result parameters
Description
Angle setpoint between workpiece surface and 1st axis in the plane of the
active WCS
Angle setpoint between workpiece surface and 2nd axis in the plane of the
active WCS
Angle actual value between workpiece surface and 1st axis in the plane
of the active WCS
Angle actual value between workpiece surface and 2nd axis in the plane
of the active WCS
Angle difference around the 1st axis of the plane
Angle difference around the 2nd axis of the plane
Angle offset value
Angle offset value around the 1st axis of the plane
Measuring variants
3.3 Measure workpiece (milling)
Unit
-
-
-
mm
mm
mm
Unit
Degrees
Degrees
Degrees
Degrees
Degrees
Degrees
Degrees
Degrees
199