Cycle994 Measuring Cycle Parameters - Siemens SINUMERIK 840D sl Programming Manual

Parameter lists
4.1 Overview of measuring cycle parameters
4.1.3

CYCLE994 measuring cycle parameters

PROC CYCLE994(INT S_MVAR,INT S_KNUM,INT S_KNUM1,INT S_PRNUM,REAL S_SETV,INT S_MA,REAL
S_SZA,REAL S_SZO,REAL S_FA,REAL S_TSA,INT S_NMSP,STRING[32] S_TNAME,INT S_DLNUM,REAL
S_TZL,REAL S_TDIF,REAL S_TUL,REAL S_TLL,REAL S_TMV,INT S_K,INT S_EVNUM,INT S_MCBIT,INT
_DMODE,INT _AMODE)
Table 4-3 CYCLE994 call parameters
No. Screen Cycle pa‐
form param‐ rameters
eters
1
S_MVAR
2 Selection
S_KNUM
306
1)
Meaning
Measuring variant
Val‐ UNITS: Inside or outside measurement (default = 1)
ues:
1 = Inside measurement
2 = Outside measurement
TENS: Reserved
HUNDREDS: Correction target
0 = Only measurement (no correction of the WO or no tool offset)
1 = Measurement and determination and correction of the WO (see S_KNUM)
2 = Measurement and tool offset (see S_KNUM1)
THOUSANDS: Bypass area
0 = no bypass area
1 = bypass axis 1st axis of the plane (for G18 Z) Measuring axis, see S_MA.
2 = bypass axis 2nd axis of the plane (for G18 X) Measuring axis, see S_MA.
3 = bypass axis 3rd axis of the plane (for G18 Y). Measuring axis, see S_MA.
Correction of work offset (WO) or basic WO or basic reference
Val‐ UNITS:
ues:
TENS:
0 = No correction
1 to max. 99 numbers of the work offset or
1 to max. 16 numbers of the basic offset
HUNDREDS: Reserved
THOUSANDS: Correction of WO or basic or basic reference
0 = Correction of the adjustable WO
1 = Correction of the channel-specific basic WO
2 = Correction of the basic reference
3 = Correction of the global basic WO
9 = Correction of the active WO or for G500 in last active channel-specific basic
WO
TEN THOUSANDS: Coarse or fine correction in the WO, basic WO or basic
reference
0 = Fine correction
1 = Coarse correction
6)
Programming Manual, 12/2017, 6FC5398-4BP40-6BA1
3)
8)
2)
Measuring cycles