Siemens SINUMERIK 840D sl Programming Manual page 133

The "3D probe with spindle reversal" function is shown if bit 16 is set in the general SD 54760
1)
$SNS_MEA_FUNCTION_MASK_PIECE .
The "Align 3D probe" function is shown if bit 17 is set in the general SD 54760 $SNS_MEA_FUNCTION_MASK_PIECE .
2)
Other parameters and correction targets can be set in the general SD 54760 $SNS_MEA_FUNCTION_MASK_PIECE .
3)
Measuring variant, turning on a milling machine (only 840D sl)
Procedure
The part program or ShopTurn program to be edited has been created and you are in the editor.
Parameter
ShopTurn program
Parameters
T
D
Measuring method
X
Y
Z
List of the result parameters
The measuring variant "Set edge" provides the following result parameters:
Table 3-14
Parameters
_OVR [0]
_OVR [1]
Measuring cycles
Programming Manual, 12/2017, 6FC5398-4BP40-6BA1
Machine manufacturer
Please observe the information provided by the machine manufacturer.
1. Press the "Meas. workp." softkey.
2. Press the "Edge distance" softkey.
3. Press the "Set edge" softkey.
The input window "Measure: Edge" opens.
Description
Name of the probe
Cutting edge number (1 - 9)
● Standard measuring method
● 3D probe with spindle reversal
● Align 3D probe
Calibration data set (1 - 40)
(only for measuring without spindle reversal)
Start point X of the measurement
Start point Y of the measurement
Start point Z of the measurement
"Set edge" result parameters
Description
Setpoint value for measuring axis
Setpoint in 1st axis of the plane → only for S_MA=1
3.3 Measure workpiece (milling)
1)
2)
Measuring variants
Unit
-
-
-
-
mm
mm
mm
Unit
mm
mm
133