Siemens SINUMERIK 840D sl Programming Manual page 327

No Screen Cycle pa‐
. form pa‐ rameters
rameters
2 Selection
S_KNUM
3 Icon+
S_PRNUM
number
4
S_SETV
5 DFA
S_FA
6 TSA
S_TSA
7 Alpha 0
S_STA1
8 Alpha 1
S_INCA
9 X1
S_SETV0
10 Y1
S_SETV1
11 Z1
S_SETV2
12 X2
S_SETV3
13 Y2
S_SETV4
14 Z2
S_SETV5
15 X3
S_SETV6
16 Y3
S_SETV7
17 Z3
S_SETV8
18 TVL
S_TNVL
19 Measure‐
S_NMSP
ments
20
S_MCBIT
Measuring cycles
Programming Manual, 12/2017, 6FC5398-4BP40-6BA1
Meaning
Correction in work offset (WO) or basic or basic reference
Val‐ UNITS:
ues:
TENS:
0 = No correction
1 to max. 99 numbers of the work offset or
1 to max. 16 numbers of the basic offset
HUNDREDS: Reserved
THOUSANDS: Correction in WO or basic WO or basic reference
0 = Correction in adjustable WO
1 = Correction in channel-specific basic WO
2 = Correction in basic reference
3 = Correction in global basic WO
9 = Correction in active WO or for G500 in last active channel-specific basic WO
TEN THOUSANDS: Correction in WO or basic WO or basic reference coarse or
fine
0 = Fine correction
1 = Coarse correction
Number of the field of the probe parameters (not probe number)
(value range 1 to 40)
Diameter of the sphere(s)
Measurement path
Safe area
Starting angle for measurement at an angle
Incremental angle for measurement at an angle
Position setpoint of the 1st sphere of the 1st axis of the plane (for G17 X) for 3 sphere
measurement
Position setpoint of the 1st sphere of the 2nd axis of the plane (for G17 Y) for 3 sphere
measurement
Position setpoint of the 1st sphere of the 3rd axis of the plane (for G17 Z) for 3 sphere
measurement
Position setpoint of the 2nd sphere of the 1st axis of the plane for 3 sphere measurement
Position setpoint of the 2nd sphere of the 2nd axis of the plane for 3 sphere measurement
Position setpoint of the 2nd sphere of the 3rd axis of the plane for 3 sphere measurement
Position setpoint of the 3rd sphere of the 1st axis of the plane for 3 sphere measurement
Position setpoint of the 3rd sphere of the 2nd axis of the plane for 3 sphere measurement
Position setpoint of the 3rd sphere of the 3rd axis of the plane for 3 sphere measurement
Limit value for distortion of the triangle (sum of the deviations) for 3 sphere measurement
Number of measurements at the same location
Reserved
4.1 Overview of measuring cycle parameters
7)
6)
4)
(value range 1 to 9)
2)
Parameter lists
3)
5)
327