Additional Result Parameters - Siemens SINUMERIK 840D sl Programming Manual

Parameter lists

4.3 Additional result parameters

4.3 Additional result parameters
The following table below contains the additional result parameters for the measuring variants
of the tool offset.
Parameters
_OVR [8]
_OVR [9]
_OVR [12]
_OVR [13]
_OVR [20]
_OVR [27]
_OVR [28]
_OVR [29]
_OVR [30]
_OVR [31]
_OVI [4]
_OVI [5]
_OVI [6]
_OVI [7]
_OVI [8]
_OVI [9]
_OVI [11]
_OVI [13]
Only for workpiece measurement with tool offset
1)
only for correction in the WO
2)
Only applies for the measuring variants "Rectangular pocket" and "Rectangular spigot"
3)
342
Description
Upper tolerance limit for:
1)
● Diameter of hole / circular spigot / circle segment
● Measuring axis
● Width of groove/rib
● Rectangle length in the 1st axis of the plane
Upper tolerance limit for rectangle length in the 2nd axis of the
1), 3)
plane
Lower tolerance limit for:
1)
● Diameter of hole / circular spigot / circle segment
● Measuring axis
● Width of groove/rib
● Rectangle length in the 1st axis of the plane
Lower tolerance limit for rectangle length in the 2nd axis of the
1), 3)
plane
Offset value
1)
Work offset range
1)
Safe area
1)
Dimensional difference
1)
Empirical value
1)
Mean value
1)
Weighting factor
1)
Probe number
Mean value memory number
1)
Empirical value memory number
1)
Tool number
1)
Alarm number
1)
Status offset request
2)
DL number
1)
Programming Manual, 12/2017, 6FC5398-4BP40-6BA1
Unit
mm
mm
mm
mm
mm
mm
mm
mm
mm
mm
-
-
-
-
-
-
-
-
Measuring cycles