Hole - Inner Circle Segment (Cycle979) - Siemens SINUMERIK 840D sl Programming Manual

ShopTurn program
Parameter
Measuring method
X
Y
Z
List of the result parameters
The measuring variant "Hole" provides the following result parameters:
Table 3-21
Parameters
_OVR [0]
_OVR [1]
_OVR [2]
_OVR [4]
_OVR [5]
_OVR [6]
_OVR [16]
_OVR [17]
_OVR [18]
_OVI [0]
_OVI [2]
_OVI [3]
_OVS_TNAME
For workpiece measurement with tool offset or correction in the work offset, additional
parameters are displayed, see Additional result parameters (Page 342).
3.3.15

Hole - inner circle segment (CYCLE979)

Function
This measuring variant can be used to measure a circle segment from the inside. The diameter
and the center point of the circle segment in the plane are determined. With the selection
setpoint value center point "YES", the position of the circle segment center can be defined as
the workpiece zero by means of setpoint specifications.
Measuring cycles
Programming Manual, 12/2017, 6FC5398-4BP40-6BA1
Description
● Standard measuring method
● 3D probe with spindle reversal
● Align 3D probe
Calibration data set (1 - 40)
(only for measuring without spindle reversal)
Start point X of the measurement
Start point Y of the measurement
Start point Z of the measurement
"Hole" result parameters
Description
Hole diameter setpoint
Hole center point setpoint in the 1st axis of the plane
Hole center point setpoint in the 2nd axis of the plane
Hole diameter actual value
Hole center point actual value in the 1st axis of the plane
Hole center point actual value in the 2nd axis of the plane
Hole diameter difference
Hole center point difference in the 1st axis of the plane
Hole center point difference in the 2nd axis of the plane
D number or WO number
Measuring cycle number
Measuring variant
Tool name
3.3 Measure workpiece (milling)
1)
2)
Measuring variants
Unit
-
-
mm
mm
mm
Unit
mm
mm
mm
mm
mm
mm
mm
mm
mm
-
-
-
-
173