Cycle996 Measuring Cycle Parameters - Siemens SINUMERIK 840D sl Programming Manual

Parameter lists
4.1 Overview of measuring cycle parameters
No Screen Cycle pa‐
. form param‐ rameters
eters
18
_AMODE
All default values = 0 or marked as the range of values a to b
Display depends on the general SD54760 $SNS_MEA_FUNCTION_MASK_PIECE
1)
Parameters are currently not used and also not displayed in the input screen.
2)
The parameter incremental angle S_INCAis permanently set to 90 degrees.
Value range of starting angle -360 to +360 degrees
3)
for dimensional tolerance yes:
4)
If the measured angle is less than the value of the work offset range TZL, then the result parameters for the angle (_OVR[2],
_OVR[3]) and deviations (_OVR[7], _OVR[8]) are set to zero.
DisplayTZL is realized using the general SD54760 $SNS_MEA_FUNCTION_MASK_PIECE bit25=1.
(enable selected zero offset when measuring angularity, spindle)
Parameter TSA refers to the 1st measurement of the calibration sphere.
5)
4.1.12

CYCLE996 measuring cycle parameters

PROC CYCLE996(INT S_MVAR,INT S_TC,INT S_PRNUM,REAL S_SETV,REAL S_STA1,REAL S_SETV0,REAL
S_SETV1,REAL S_SETV2,REAL S_SETV3,REAL S_SETV4,REAL S_SETV5,REAL S_TNVL,REAL S_FA,REAL
S_TSA,INT S_NMSP,INT S_MCBIT,INT _DMODE,INT _AMODE)
330
Meaning
Alternative mode
Val‐ UNITS: Dimensional tolerance yes/no
ues:
0 = No
1 = Yes
Programming Manual, 12/2017, 6FC5398-4BP40-6BA1
Measuring cycles