Siemens SINUMERIK 840D sl Programming Manual page 183

Parameter Description
Dimensional toler‐ Use dimensional tolerance for tool offset
ance
● Yes
● No
TUL Workpiece upper tolerance limit (incremental to the setpoint, only for dimensional tolerance
"Yes")
TLL Workpiece upper tolerance limit (incremental to the setpoint, only for dimensional tolerance
"Yes")
The "3D probe with spindle reversal" function is shown if bit 16 is set in the general SD 54760
1)
$SNS_MEA_FUNCTION_MASK_PIECE .
The "Align 3D probe" function is shown if bit 17 is set in the general SD 54760 $SNS_MEA_FUNCTION_MASK_PIECE .
2)
Other parameters and correction targets can be set in the general SD 54760 $SNS_MEA_FUNCTION_MASK_PIECE .
3)
The contact angle always refers to the positive direction of the 1st axis of the active coordinate system, e.g. for G17 to +X,
4)
G18/+Z, G19/+Y
Measuring variant, turning on a milling machine (only 840D sl)
Procedure
The part program or ShopTurn program to be edited has been created and you are in the editor.
Parameter
ShopTurn program
Parameter
T
D
Measuring method
X
Y
Z
Measuring cycles
Programming Manual, 12/2017, 6FC5398-4BP40-6BA1
Machine manufacturer
Please observe the information provided by the machine manufacturer.
1. Press the "Meas. workp." softkey.
2. Press the "Spigot" softkey.
3. Press the "Rectangular spigot" softkey.
The input window "Measure: Rectangular spigot" opens.
Description
Name of the probe
Cutting edge number (1 - 9)
● Standard measuring method
● 3D probe with spindle reversal
● Align 3D probe
Calibration data set (1 - 40)
(only for measuring without spindle reversal)
Start point X of the measurement
Start point Y of the measurement
Start point Z of the measurement
3.3 Measure workpiece (milling)
1)
2)
Measuring variants
Unit
-
mm
mm
Unit
-
-
-
-
mm
mm
mm
183