Siemens SINUMERIK 840D sl Programming Manual page 326

Parameter lists
4.1 Overview of measuring cycle parameters
Table 4-10 CYCLE997 call parameters
No Screen Cycle pa‐
. form pa‐ rameters
rameters
1
S_MVAR
326
1), 2)
Meaning
Measuring variant (default =9)
Val‐ UNITS: Contour element
ues:
9 = Measure sphere
TENS: Repeat measurement
0 = Without measurement repetition
1 = With measurement repetition
HUNDREDS: Correction target
0 = Only measurement (no correction of WO)
1 = Measurement and determination and correction of the WO (see S_KNUM)
THOUSANDS: Measuring strategy
0 = Paraxial measurement, without starting angle, probe alignment corresponding
to SD55740, bit 1
1 = Circling measurement, with starting angle, probe alignment corresponding to
SD55740, Bit 1
2 = Circling measurement, with starting angle, align probe in the switching direction
3 = Paraxial measurement, with starting angle, probe alignment corresponding to
SD55740, bit 1
4 = Paraxial measurement, with starting angle, align probe in the switching direction
TEN THOUSANDS: Number of spheres to be measured
0 = Measure one sphere
1 = Measure three spheres
HUNDRED THOUSANDS: Number of measuring points, only for measurement at
an angle (note measuring strategy: THOUSANDS position > 0)
0 = Three measuring points for measurement at an angle (traversing around the
sphere)
1 = Four measuring points for measurement at an angle (traversing around the
sphere)
ONE MILLION: Determination of the diameter setpoint of the sphere
0 = No determination of the diameter setpoint of the sphere
1 = Determination of the diameter setpoint of the sphere
Programming Manual, 12/2017, 6FC5398-4BP40-6BA1
Measuring cycles