Siemens SINUMERIK 840D sl Programming Manual page 151

Measuring variant, turning on a milling machine (only 840D sl)
Procedure
The part program or ShopTurn program to be edited has been created and you are in the editor.
Parameter
ShopTurn program
Parameter
T
D
Measuring method
X
Y
Z
List of the result parameters
The measuring variant "Rib" provides the following result parameters:
Table 3-17
Parameters
_OVR [0]
_OVR [1]
_OVR [2]
_OVR [4]
_OVR [5]
_OVR [6]
_OVR [16]
_OVR [17]
_OVR [18]
_OVI [0]
Measuring cycles
Programming Manual, 12/2017, 6FC5398-4BP40-6BA1
1. Press the "Meas. workp." softkey.
2. Press the "Edge distance" softkey.
3. Press the "Rib" softkey.
The input window "Measure: Rib" opens.
Description
Name of the probe
Cutting edge number (1 - 9)
● Standard measuring method
● 3D probe with spindle reversal
● Align 3D probe
Calibration data set (1 - 40)
(only for measuring without spindle reversal)
Start point X of the measurement
Start point Y of the measurement
Start point Z of the measurement
"Rib" result parameters
Description
Rib width setpoint
Rib center setpoint in the 1st axis of the plane
Rib center setpoint in the 2nd axis of the plane
Rib width actual value
Rib center actual value in the 1st axis of the plane
Rib center actual value in the 2nd axis of the plane
Rib width difference
Rib center difference in the 1st axis of the plane
Rib center difference in the 2nd axis of the plane
D number or WO number
3.3 Measure workpiece (milling)
1)
2)
Measuring variants
Unit
-
-
-
-
mm
mm
mm
Unit
mm
mm
mm
mm
mm
mm
mm
mm
mm
-
151