Siemens SINUMERIK 840D sl Programming Manual page 149

Parameter
G code program
Parameter Description
Measuring
● Standard measuring
method
method
● 3D probe with spindle
reversal
● Align 3D probe
PL Measuring plane (G17 - G19)
Calibration data set (1 - 40)
(only for measuring without
spindle reversal)
Parameter Description
Correction target
● Measuring only (no offset)
● Work offset (save measured values in a settable WO)
–
–
● Basis reference
–
● Channel-specific basis
–
–
● Tool offset (save measured values in the tool data)
TR Name of tool to be corrected
D Cutting edge number of tool to be corrected (1-9)
● Geometry: Save measured values in the tool geometry
● Wear: Save measured values in the tool wear
Measuring cycles
Programming Manual, 12/2017, 6FC5398-4BP40-6BA1
Unit
-
1)
2)
-
-
Save measured values in a settable work offset (active WO, G54, G55, G56, G57,
G505, G506)
Coarse/fine (save measured value in coarse offset/save measured value in fine
offset)
Coarse/fine (save measured value in coarse offset/save measured value in fine
offset)
Save measured values in frame number (1-4)
Coarse/fine (save measured value in coarse offset/save measured value in fine
offset)
3.3 Measure workpiece (milling)
ShopMill program
Parameter Description
T Name of the probe
D Cutting edge number (1 - 9)
Measuring
● Standard measuring
method
method
● 3D probe with spindle
reversal
● Align 3D probe
Calibration data set (1 - 40)
(only for measuring without
spindle reversal)
X Start point X of the measure‐
ment
Y Start point Y of the measure‐
ment
Z Start point Z of the measure‐
ment
3)
Measuring variants
Unit
-
-
-
1)
2)
-
mm
mm
mm
Unit
-
-
-
-
149