Siemens SINUMERIK 840D sl Programming Manual page 264

Measuring variants
3.5 Measure tool (turning)
Parameters Description
TZL Tolerance range for work offset
TDIF Tolerance range for dimensional difference monitoring
Measuring variant, milling on a turning machine
Procedure
The part program or ShopMill program to be edited has been created and you are in the editor.
Parameters
ShopMill program
Parameter
T
D
F
X
Y
Z
List of the result parameters
The measuring variant "Turning tool" provides the following result parameters:
Table 3-39
Parameter
_OVR[8]
_OVR[9]
_OVR[10]
_OVR[11]
_OVR[12]
_OVR[13]
_OVR[27]
_OVR[28]
_OVR[29]
264
1. Press the "Meas. tool" softkey.
2. Press the "Turning tool" softkey.
Description
Name of the probe
Cutting edge number (1 - 9) -
Calibration data set (1 - 6)
Calibration and measuring
feedrate
Start point X of the meas‐
urement
Start point Y of the meas‐
urement
Start point Z of the meas‐
urement
"Turning tool" result parameters
Description
Length actual value L1
Length difference L1
Length actual value L2
Length difference L2
Length actual value L3
Length difference L3
Work offset range
Safe area
Permissible dimensional difference
Unit
-
-
mm/min
mm
mm
mm
Programming Manual, 12/2017, 6FC5398-4BP40-6BA1
Unit
mm
mm
Unit
mm
mm
mm
mm
mm
mm
mm
mm
mm
Measuring cycles