3. To remove overrunning clutch, expand pinion stop nut
as shown and remove front side. Remove snap ring,
then remove rear side of pinion stop nut and overrun
ning clutch.
Starter Motor Parts Cleaning
1. Do not immerse parts in solvent for cleaning. Immer
sion of yoke, field coil assembly or armature in solvent
causes damage to the insulation. Wipe these parts with
a cloth to clean if necessary.
2. Do not immerse drive unit in cleaning solvent. The
overrunning clutch has been lubricated at the factory
and cleaning by a solvent removes the lubricant. Clean
the drive unit using a brush wetted with a cleaning sol
vent, then wipe dry with a cloth.
Starter Inspection
1. Put armature on a pair of V–blocks and check runout
using a dial indicator.
2. Check O.D. of commutator.
Liquid Cooled Gas Engine
Pinion stop nut
Snap ring
Pinion stop
nut (rear)
Page 3 – 66
Snap ring
Figure 117
Snap ring
pliers
Overrunning clutch
Figure 118
Dial gauge
V–block
Figure 119
Figure 120
Workman 3000/4000 Series